What is the application process of the clamp? Next we will give a relevant introduction:

1. Cut the steel pipe to the required length with a pipe cutter, and check the section of the cut with a level gauge to ensure that the section of the cut is perpendicular to the central axis of the steel pipe. If the incision has burrs, apply a grinder to smooth it.

2. The clamp will be placed on the tail groove of the rolling groove machine and the grooved machine at the tail groove of the grooved machine and the grooved machine, so that the steel pipe is in a horizontal position.

Clamp

3. The clamp closes the processing section of the steel pipe to the rolling groove machine so that the central axis of the steel pipe is perpendicular to the rolling surface.

4. Slowly press down. Jack, make the upper pressure roller close to the steel pipe, start the rolling groove machine, and make the roller rotate one week. At this time, pay attention to whether the steel pipe section is still close to the rolling groove machine. If it is not tight, adjust the pipe to the level. If it is tight, slowly press down the jack so that the upper pressure roller rolls the steel pipe evenly to the predetermined groove depth.

5. When the clamp is stopped, check the groove depth and width with a vernier caliper. After confirming that the standard is met, unload the jack and take out the steel pipe.

In the application process of the clamp, it is necessary to grasp the precautions, and pay attention to maintenance after use to extend its life.

The rubber soft joint adopts a clamp instead of the flange and the bolt. When installing, the two nozzles of the clamp type rubber joint can be respectively set on the pipe to be connected, and the rubber joint is fixedly connected with the pipe through the clamp.